Removing A Usb Embedded Hypervisor Flash Device - IBM x3690 X5 Service Manual
Hide thumbs
Also See for x3690 X5:
- Installation and user manual (180 pages) ,
- Product manual (42 pages) ,
- At-a-glance manual (34 pages)
Table of Contents
Advertisement
5. Install the cover.
6. Slide the server into the rack.
7. Reconnect the power cords and all external cables, and turn on the server and
Removing a USB embedded hypervisor flash device
To remove a hypervisor flash device, complete the following steps:
1. Read the safety information and installation guidelines, see "Safety" on page vii
2. Turn off the server (see "Turning off the server" on page 17) and all attached
3. Remove the top cover (see "Removing the server top cover" on page 264).
4. Locate the USB embedded hypervisor flash device connector on the one-slot
322
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
PCI riser assembly
(slot 2)
Flash power
module
Flash power
module tray
peripheral devices.
and "Installation guidelines" on page 261.
peripheral devices. Disconnect all power cords; then, disconnect all external
cables as necessary to replace the device.
side of the x8 low-profile riser-card as shown in the following illustration:
Remote flash
power module
cable
Advertisement
Table of Contents
