IBM x3690 X5 Service Manual page 240

Table 11. IMM error messages detected when MAX5 is attached to the server (continued)
Event ID
806f0507-2584xxxx
806f0507-2584xxxx
806f032b-2101xxxx
222
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
Message
CPU Type Check has a
configuration mismatch
Missing Boot CPU has
recovered from a
configuration mismatch
Missing Boot CPU has a
configuration mismatch
Memory Expansion Unit 1
detected as absent
A hardware change occurred
on system Host
The firmware or software on
system Host are compatible
A hardware change occurred
on system Host
A firmware or software
incompatibility was detected
on the system Host
Numeric sensor Fan n
detected as present.
Numeric sensor Fan n
detected as absent.
Severity Description
Error A configuration
mismatch was
detected on the CPU
Type Check.
Info The missing boot
CPU has recovered
from a configuration
mismatch.
Error A CPU is missing
from microprocessor
socket 1.
Info The MAX5 memory
expansion module is
not working
properly.
Info Changes were made
to the host system
hardware.
Info The required
firmware and
software are
compatible.
Info The host system
hardware was
changed.
Error The FPGA firmware
between the memory
expansion module
and the host system
does not match.
Info A fan was detected
as being present.
Info A fan was detected
as being absent.
Action
1. Check to make
sure that matched
microprocessors
are installed. See
"Replacing a
microprocessor
and heat sink" on
page 351 for
information about
installation
requirements.
2. (Trained service
technician only)
Replace the
microprocessor.
No action;
information only.
(Trained service
technician only)
Install a
microprocessor in
microprocessor
socket 1.
Check the MAX5
memory expansion
module cables and
power connections.
No action;
information only.
No action;
information only.
No action;
information only.
Update all firmware
to the latest level (see
"Updating the
firmware" on page
397).
No action;
information only.
No action;
information only.