IBM x3690 X5 Service Manual page 216

Table 10. System x3690 X5 IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v See Chapter 4, "Parts listing, System x3690 X5 Types 7147, 7148, 7149, and 7192," on page 249 to determine which components
are customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service
technician.
Event ID Message
806f0108-0a01xxxx The Power Supply (Power Supply: n)
806f0108-0a02xxxx has Failed.(n = power supply number)
806f0108-0a03xxxx
806f0108-0a04xxxx
806f0109-1381xxxx Host Power has been Power Cycled
806f010c-0781xxxx Uncorrectable error detected for
Memory Device n on subsystem
System Memory.
198
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
Severity Description
Error Power supply n has
failed.(n = power
supply number)
Info The management
controller has
detected a power
unit that has been
power cycled.
Error A memory
uncorrectable error
has occurred.
Action
1. If the power-on LED is
lit, complete the
following steps:
a. Reduce the server to
the minimum
configuration.
b. Reinstall the
components one at a
time, restarting the
server each time.
c. If the error recurs,
replace the
component that you
just reinstalled.
2. Reseat power supply n.
3. Replace power supply
n.
(n = power supply number)
Information only; no action
is required.
1. Check IBM support site
for an applicable
RETAIN tip or firmware
update that applies to
this memory error.
2. Swap the affected
DIMM with a DIMM of
the same size and type
from a different
memory channel.
3. Run the Setup utility to
enable all the DIMMs.
4. If the DIMM still fails
on a different memory
channel, replace the
DIMM.
5. If the swapped DIMM
fails on the original
DIMM connector,
inspect the DIMM
connector for debris or
damage. If the
connector is damaged,
(trained technician only)
replace the system
board.