IBM x3690 X5 Service Manual page 336

5. Route the remote battery cable in the server and through the slots on the RAID
318
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
b. Connect the battery cable to the battery cable connector on the battery
carrier.
c. Place the battery carrier in the RAID battery tray mounting slot on the
RAID battery tray and ensure that battery carrier posts align with the rings
on the battery mounting slot so that the battery carrier is secure in the slot.
Note: The positioning of the remote battery depends on the type of remote
battery that you install.
d. Take the battery retention clip and place it underneath the tab while
pressing the release tab toward the side of the server; then, press it down
until it snaps in place to hold the battery carrier firmly in place.
battery tray as shown in the following illustrations (depending on the PCI slot
in which the RAID adapter is installed).
Attention: Make sure that the cable is not pinched and does not cover any
connectors or obstruct any components on the system board.