Table 11. IMM error messages detected when MAX5 is attached to the server (continued)
Event ID
806f030c-1881xxxx
Message
Scrub Failure for "MEU
DIMMs" on subsystem
"System Memory"
Severity Description
Error
A Memory Scrub
failure has been
detected.
Action
1. Check IBM
support site for
an applicable
RETAIN tip or
firmware update
that applies to
this memory
error.
2. Swap the affected
DIMM with a
DIMM of the
same size and
type from a
different memory
channel.
3. Run the Setup
utility to enable
all the DIMMs.
4. If the DIMM still
fails on a
different memory
channel, replace
the DIMM.
5. If the swapped
DIMM fails on
the original
DIMM connector,
inspect the
DIMM connector
for debris or
damage. If the
connector is
damaged,
(trained
technician only)
replace the MAX5
system board
tray.
231
Chapter 3. Diagnostics