IBM x3690 X5 Service Manual page 194

Table 10. System x3690 X5 IMM error messages (continued)
v Follow the suggested actions in the order in which they are listed in the Action column until the problem is solved.
v See Chapter 4, "Parts listing, System x3690 X5 Types 7147, 7148, 7149, and 7192," on page 249 to determine which components
are customer replaceable units (CRU) and which components are field replaceable units (FRU).
v If an action step is preceded by "(Trained service technician only)," that step must be performed only by a trained service
technician.
Event ID Message
80070219-0701xxxx Sensor Sys Board Fault has
transitioned to critical from a less
severe state.
8007021b-0301xxxx Sensor Int QPI Link 1 : has
transitioned to critical from a less
severe state.
176
System x3690 X5 Types 7147, 7148, 7149, and 7192: Problem Determination and Service Guide
Severity Description
Error A sensor has
changed to Critical
state from a less
severe state.
Warning The management
controller has
detected a Sensor
transitioned to
critical from less
severe.
Action
1. Check the system-event
log.
2. Check for an error LED
on the system board.
3. Replace any failing
device.
4. Check for a server
firmware update.
Important: Some cluster
solutions require
specific code levels or
coordinated code
updates. If the device is
part of a cluster
solution, verify that the
latest level of code is
supported for the
cluster solution before
you update the code.
5. (Trained service
technician only) Replace
the system board.
1. Check the system-event
log in the UEFI F1
Setup Utility screen.
2. Check the
microprocessor error
LEDs.
3. (Trained service
technician only) Remove
the failing
microprocessor (see
"Removing a
microprocessor and heat
sink" on page 349 and
"Replacing a
microprocessor and heat
sink" on page 351).
4. Check for a UEFI,
FPGA, and IMM
firmware update (see
"Updating the
firmware" on page 397
for information on
updating the firmware).
5. Make sure that the
microprocessors are
matching.
6. (Trained service
technician only) Replace
the system board.