Basic Editing ─ Selecting A Network And Operation - Delta AS Series Operation Manual

Hide thumbs Also See for AS Series:

Table of Contents

Send Quote Requests to info@automatedpt.com

 To insert a normally-closed contact (contact B), type "B <device address>"

 To insert an output coil (OUT), type "O <device address>"

Basic Editing ─ Selecting a Network and Operation

Before you select an object in a network, press Esc on the keyboard, or click

cursor appears as a small arrow, click the object in the network. The basic selection shows below.

Select the network

Select the input contact

Select the network

Select the output coil

Select the block

To select a group of devices, click a device and drag it to draw a frame around the group of devices. You can

also select the group of devices by clicking the first device, pressing Ctrl+B on the keyboard, clicking the last

device, and then pressing Ctrl+B on the keyboard. You must draw a frame around devices that are in the

same network, and the devices must be adjacent to one another. Input and output devices cannot be in the

Send Quote Requests to info@automatedpt.com

Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com

on the toolbar. After the

Show Quick Links

Table of Contents

Troubleshooting