Delta AS Series Operation Manual page 317

Send Quote Requests to info@automatedpt.com
In the online monitoring mode, you can select a device, then right-click the device, and the click a command
on the context menu. During a test, you can change the status of a device or the value in a device by clicking
an item on the context menu.
Before you change the status of a device, make sure the operation does not cause damage to
equipment or personnel.
The table below describes the items in the context menu. The Force command only applies to input and
output contacts.
Rising-edge Trigger
Falling-edge Trigger
Force Device List
To change the value in a device, right-click the device, click Change Present Value, and set a present value
in the Enter Present Value dialog box.
Item
Set On Set the contact selected to ON
Set Off Set the contact selected to OFF
No matter what the state of the selected contact is, the system sets the contact
to OFF, and then sets it to ON.
No matter what the state of the selected contact is, the system sets the contact
to ON, and then sets it to OFF.
Force Force an input contact or output contact ON or OFF
Force several input contacts or output contacts in the tables ON or OFF
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Description