Delta AS Series Operation Manual page 583

Send Quote Requests to info@automatedpt.com
OFF state.
The sending registers exceed the
19FB
range.
The receiving registers exceed the
19FC
range.
Not using the FCOMP card or not in the
right mode for the ASDA-A2 while using
2001
the CANopen communication
instruction.
The device used in the program
2003
exceeds the device range.
The operand n or the other constant
200B
operands K/H exceed the range.
200C The operands overlap.
The binary to binary-coded decimal
200D
conversion is incorrect.
200E The string does not end with 00.
2012 Incorrect division operation
The value exceeds the range of values
2013 that can be represented by the floating-
point numbers.
The task designated by the TKON or
2014 YKOFF instruction is incorrect or
exceeds the range.
The instruction BREAK is written
2017
outside of the FOR-NEXT loop.
No such position planning table number
2027
or the format is incorrect.
High speed output instruction is being
2028 executed. Only one instruction can be
executed at a time.
During the execution of CSFO
2030 instruction, the output frequency
exceeds the upper limit.
During the execution of CSFO
instruciotn, when the output frequency
2031
is set to 0, but even after 2 seconds, the
output is still not complete.
6004 The IP address filter is set incorrectly.
600D RJ45 port is not connected.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
shielded cable is grounded.
2. Check if the start and end of the network cable
are both connected with a 121Ω terminal
resistor.
3. Check if all the node devices run at the same
baud rate on the network.
Revise the time to synchronize (suggested to use a
longer time).
Revise the time to synchronize (suggested to use a
longer time).
1. Use the FCOMP card in the function card slot to
check if the operation mode is correct.
2. Check the syntax error step in the program.
Modify and compile the program and then
download the program again.
Check the syntax error step in the program. Modify
and compile the program and then download the
program again.
1. Check the syntax error step in the program.
Modify and compile the program and then
download the program again.
2. Check the settings of the position planning table.
Refer to SR28 for the record of the axis number
and rearrange the output control procedures.
Modify the ratio of input / output frequency or lower
the inut frequency value.
Set the Ethernet parameter for the CPU module in
HWCONFIG again.
Check the connection.
- V
- V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
SM0 V
V
-
V
-
V
-
SM1108 X
SM1100 X