Delta AS Series Operation Manual page 393

Send Quote Requests to info@automatedpt.com
COM1 and COM2 is via the Modbus protocol; if the data exchange through Ethernet is via the Modbus TCP protocol.
The setting items for COM1, COM2 and Ethernet are the same.
 You can set the three Modes to start data exchange.
A. Program Control: PLC decides whether or not to execute the set flags for data exchange. Refer to
B. PLC Run: The set data exchange will be executed automatically when PLC is in RUN state. If the PLC is in
C. Always Enable: The data exchange will be executed constantly after PLC is powered on.
 Function buttons and descriptions:
special flags (SM) descriptions for more details in AS Series Programming
Manual.
STOP state, the communication will stop.
Function Button
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Description
Click Add to add a new data exchange item in area .
Click Edit to enter the selected data exchange setting
page.
Select the data exchange item and click Move Up and
Move Down to rearrange the order of data exchange
table.
Select the data exchange item and click Copy and the
copied item will be pasted to the last raw of the data
exchange table.
Select the data exchange item and click Delete to delete
the selected item.
Click Delete All to delete all data exchange items
presented.
Select this option to detect if the assigned slaves of the
data exchange table exist. If the slave does NOT exist,
the connection to the slave will stop to increase
efficiency.
Note: It is suitable for applications that the time it takes