Delta AS Series Operation Manual page 429

Send Quote Requests to info@automatedpt.com
No. Category
exchange
table
Item
EIP Tag
Product name
Name
IP Address
Scanner Start Address /
EIP Tag
Adapter Start Address /
EIP Tag / Parameter
Length (byte)
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Description
You must create a Consumed Tag in the Global Symbols in
ISPSoft before using this function.
Use EIP Tag to perform data exchange with adapters.
After selecting this check box,

The directional arrow points left of () (READ only)

Registers cannot be used in this row.

The length format is defined by the data format in the
Global Symbols; you cannot change the length format
here.

Refer to section 9.4.6 for more information.
Once you select the IP address, its name is displayed. And it
cannot be changed here.
Go to the network view to change the device name. Refer to
section 9.4.3.3 for more information.
The IP address of the Adapter for the Scanner to connect to.
After the data exchange connection is established, the system
loads the connected devices' IP addresses. After that you can
select the device's IP address from the list to add or edit the
connection.
Starting address of the Scanner register in the data exchange
table
FW V1.08 or previous versions support device D.
FW V1.10 or later version support device D and M.
Using device D or device M takes 2 bytes as a unit in data length.
Starting address of the target Adapter register in the data
exchange table / EIP Tag / Parameters
Set the data exchange length. The data length is set according
to EDS file and the maximum is 500 bytes; unit: byte. You cannot
change the length here when using EIP Tag.