Delta AS Series Operation Manual page 442

Send Quote Requests to info@automatedpt.com Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
5. Create a component and then you can use the imported tags from the previous step.
6. After the setting is complete, download the DOPSoft project to HMI.
9.4.6.2 Consumed Tag
The way to create a consumed Tag is the same the way to create a Produced Tag. Refer the section above for more
information. After the setups are complete, download the parameters to the PLC, even if using one's own EIP data
exchange table.
9.4.6.3 Use Tag to Execute Data Exchange
1. Make sure Consumed Tag is created. After the ISPSoft project is saved, open HWCONFIG.
2. Refer to section 9.4.3 to 9.4.4 for adding devices in the network. And then Enter the IP address of the Produced Tag
device to be connected. The length of the produced tag and the consumed tag should be exactly the same.
3. Switch to the data exchange setting page.
4. Once you select the Tag check box, the directional arrow is to the left with () (READ only)
5. Select the created Consumed Tag from ISPSoft and HWCONFIG will bring in the length automatically. It does not
require further setting.
6. Enter the Produced Tag name of the remote device in the Adapter's EIP tag table. After that you can download the EIP
tag table in HWCONFIG.
rd
7. For the 3 party device, after importing the EDS file, the procedures of using tags to perform data exchange are the
same. EDS file. If there is no EDS file, you can use General Device to set up. The only requirement is the IP address, no
need to set up input, output, instances, you can use tags to perform data exchange.
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com