Delta AS Series Operation Manual page 244

Send Quote Requests to info@automatedpt.com
(2) The 24 VDC cable should be twisted and connected to a module within a short distance.
(3) Do not bundle 110 VAC cable, 220 VAC cable, 24 VDC cable, the (high-voltage high-current) main circuit,
and the I/O signal cable together. The distance between adjacent cables should be more than 100
millimeters.
(4) Connect a cable with a diameter of 14 AWG or higher to ground.
(5) Use single-wire cables or two-wire cables with a diameter of 20 AWG to 14 AWG. Only use copper
conducting wires with a temperature rating of 60/75°C.
4.13.6.2
When the connected device is a PNP type
AS 04SI L-A
24 V
0V
Note: n=1~4
4.13.6.3
When the connected device is a PNP type
A S04S I L-A
24 V
0V
Note: n=1~4
Digital Input Wiring (SIO Mode)
Ln+
CQn
Ln-
2 4V
0V
Digital Output Wiring (SIO Mode)
Ln+
+
signal
CQn
Load
R
-
Ln-
2 4V
0V
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
When the connected device is a NPN type
AS 04SI L-A
24 V
Ln+
CQn
Ln-
0V
2 4V
0V
When the connected device is a NPN type
A S04S I L-A
24 V
Ln+
R
CQn
-
Ln-
0V
2 4V
0V
+
signal
Load