Delta AS Series Operation Manual page 628

Send Quote Requests to info@automatedpt.com
Troubleshooting

When SM1161 is ON and the value in SR1603 is not 0.

Read the value in SR1604 to find the last digit of the device's IP address that a most recent error occurred during
restoration to find out which device is not functioning.

Read the value in SR1605 or use the PRST_ErrRead to read the error code. See the table below for
troubleshooting.
Error Code
Type
in SR1605
PLC setting
and operation
error
Backup and
restoration
error
Error Message
H'0001 CPU module can NOT detect SD card
H'0002 No backup file in SD card.
Error occurred while reading data from
H'0003 SD card. For instance, failed to read or
the file is corrupted.
H'0004 Failed to write data into SD card.
Restoration setting error
(For example, the IP address to be
H'0008 restored is set as a broadcasting one.
For restoration, the IP address should be
one on one, not broadcasting.
H'000A Connection lost
H'1000 Not supported parameter settings
H'1001 Device series not matched
H'1002 Device version not matched
H'1003 Incompatible device voltage level
H'1004 Incompatible device power
H'1010 Device model not matched
H'1011 Incorrect device password
H'1100 Device communication timeout
Currently the device can NOT execute
H'1101
backup or restoration.
Currently the device can NOT compete
H'1103
the execution of backup or restoration.
H'1106
Device responds with incomplete data
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Solution
Make sure SD card is installed
securely. Unplug it and plug it in again.
Make sure there is a backup file in SD
card.
Check if SD card is damaged.
Check if SD card is written proof or if it
is damaged.
Check if the naming of IP address and
ID is the same as what is set in
HWCONFIG.
Check if the network cable is
well-connected and the wiring is
correct.
Check if the Delta drive's firmware
version in the backup file is matched
with the one to be restored.
Check if the Delta drive's series in the
backup file is matched with the one to
be restored.
Check if the Delta drive's firmware
version in the backup file is matched
with the one to be restored.
Check if the Delta drive's voltage level
in the backup file is matched with the
one to be restored.
Check if the Delta drive's power in the
backup file is matched with the one to
be restored.
Check if the Delta drive's model in the
backup file is matched with the one to
be restored.
Check if the Delta drive's password is
the same as what is set in HWCONFIG.
Check if the network cable is
well-connected and free from noise
interference.
If the problem persists, contact the
local authorized distributors of the
Delta drive.
If the problem persists, contact the
local authorized distributors of the
Delta drive.
If the problem persists, contact the