Delta AS Series Operation Manual page 451

Send Quote Requests to info@automatedpt.com
5. Modify the module definition
1) Name: Click the arrow button to select a valid connection.
2) Size: The example PLC supports maximum 500 bytes data size. (Data for input contains 2 bytes of Serial
Number and for output contains 4 bytes 32-bit Run-idle header and 2 bytes of Serial Number.) If using AS300, you
can set the maximum data length 498 SINT for input and 494 SINT for output.
※ In general, there is no need to change the parameters from the imported EDS files which can usually be used
without modification.
In the New Module dialog box, click the Connection tab to modify the Requested Packet Interval and Input Type
6.
settings. The RPI uses the I/O connection to a Scanner to exchange data at regular intervals, and the units are
micro-seconds. For Input Type select either Unicast or Multicast. The Input Type selections may vary for different
products.
Click OK to create the adapter. The new Delta Adapter appears in the Controller Organizer tree.
7.
9.7.1.3 Editing Corresponding Addresses for AS300
Refer to section 9.8.5 Assembly Object for defaults of exchange address. Refer to section 9.7.1.5 on how to open
Program Tag and modify the contents of Tag:C to edit the exchange addresses. Refer to section 9.8.5 Assembly Object
for details on Tag:C.
You can edit the corresponding addresses of input and output for each connection through Configuration.
Configuration
address
Word[0]
Word[1]
Word[2-3]
Word[4]
Word[5]
Word[6-7]
Data type
UINT
UINT
Number of corresponding component for
DWORD
Corresponding components for output
UINT
UINT
Number of corresponding component for
DWORD
Send Quote Requests to info@automatedpt.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Call +1(800)985-6929 To Order or Order Online At Deltaacdrives.com
Description
Corresponding components for input
0: D, 1: X, 2: Y
Reserved
input
0: D, 2: Y
Reserved
output
Defaults
(Connection 1)
0
200
1000
0
200
0