Static-Lsp Transit; Statistics Interval - HP 5800 series Command Reference Manual

static-lsp transit

Description
Use the static-lsp transit command to configure a static LSP taking the current LSR as a transit LSR.
Use the undo static-lsp transit command to remove a static LSP taking the current LSR as a transit LSR.
If you specify the next hop when configuring a static LSP, and the address of the next hop is present in the
routing table, you also need to specify the next hop when configuring the static IP route.
The address of the next hop cannot be any local public network IP address.
Related commands: static-lsp egress and static-lsp ingress.
Syntax
static-lsp transit lsp-name incoming-interface interface-type interface-number in-label in-label nexthop
next-hop-addr out-label out-label
undo static-lsp transit lsp-name
View
System view
Default level
2: System level
Parameters
lsp-name: Specifies the name for the LSP, which is a string of 1 to 15 characters.
incoming-interface interface-type interface-number: Specifies an incoming interface by its type and
number.
in-label in-label: Specifies the incoming label, ranging from 16 to 1023.
next-hop-addr: Specifies the address of the next hop.
out-label out-label: Specifies the outgoing label, which can be a 0, 3, or a value ranging from 16 to
1023.
Examples
# Configure a static LSP named bj-sh, taking the local LSR as a transit LSR, interface VLAN-interface 2 as
the incoming interface, 123 as the incoming label, 202.34.1 14.7 as the next hop address, and 253 as
the outgoing label.
<Sysname> system-view
[Sysname] static-lsp transit bj-sh incoming-interface
nexthop 202.34.114.7 out-label 253

statistics interval

Description
Use the statistics interval command to set the interval for reading collected statistics.
Use the undo statistics interval command to restore the default.
By default, the LSP statistics reading interval is 0, which indicates that the system does not read collected
LSP statistics.
vlan-interface 2 in-label
110
123