Removing And Installing The Gearbox; Removing The Gearbox; Fabia Ii - Skoda FABIA II 2007 Workshop Manual

2

Removing and installing the gearbox

2.1

Removing the gearbox; Fabia II 2007 ?

Special tools and workshop equipment required
♦ Supporting device -MP9-200 (10-222A)-
♦ Adapter -MP9-200/3 (10-222A/3)-
♦ Retaining plate -3282-
♦ Adjusting plate -T30020-
♦ Engine and gearbox jack e.g. -V.A.G 1383 A-
♦ Grease for plug serration of clutch disc -G 000 100-
Note
All cable straps which are detached or cut open when remov‐
♦
ing, should be fitted on again in the same place when installing.
♦ After the battery earth strap is disconnected and connected,
carry out additional operations ⇒ Electrical System ⇒ Rep.
Gr. 27 .
– Disconnect the earth strap from the battery with the ignition
off.
– Remove engine cover ⇒ engine ⇒ Rep. Gr. 10 .
– Remove air filter housing complete with air guide hose ⇒ En‐
gine ⇒ Rep. Gr. 23 .
– Remove battery and battery tray ⇒ Electrical System ⇒ Rep.
Gr. 27 .
– Remove lock washer -arrow 1- for shift cable from gearbox
shift lever -A-.
– Pull off shift cable from the stud.
Metal relay lever
– Remove circlip -arrow 2- for selector cable from relay lever
-B-.
– Pull selector cable off the stud.
– Detach circlip -arrow 3- from the relay lever -B- and remove
relay lever.
Note
Always replace circlips ⇒ Electronic Catalogue of Original Parts .
FABIA II 2007 ➤
Gearbox 02R - Edition 12.06
2. Removing and installing the gearbox
65