Skoda FABIA II 2007 Workshop Manual page 369

Assembly of sliding sleeve/1st and 2nd gear synchronizer body
together with arresters, which are hollow inside
• The sliding sleeve is drawn over the synchronizer body.
– Insert arresters and mount springs with 120° offset. The an‐
gled end of the spring must grip into the hollow arrester.
Assembly of sliding sleeve/1st and 2nd gear synchronizer body
together with arresters, which are not hollow inside
• The sliding sleeve is drawn over the synchronizer body.
– Insert arresters and mount springs with 120° offset. The an‐
gled ends of the springs must be located before the arresters
-arrows-.
Fitting position of the sliding sleeve and 1st and 2nd gear syn‐
chronizer body
The teeth of the sliding sleeve -arrow- point towards the serration
for the 3rd/4th gear synchronizer body -A-.
Press on the sliding sleeve and 1st and 2nd gear synchronizer
body
Rotate the synchronizer ring in such a way that the slots are flush
with the arresters.
Fabia II 2007 ➤ , Fabia II 2009 ➤ , Fabia II 2011 ➤ , Rapid 2011 ➤ , R ...
Gearbox 02R - Edition 08.2014
2. Output shaft
181