Table of Contents
Advertisement
Code
Description
20-F10
Abnormality was detected in
initialization of the loader.
21-001
The cartridge is nearing the
end of its use cycle.
21-100
This media is not available.
22-001
Two or more accesses were
frequently done to the car-
tridge at the same time.
*1: For the ODS-D380F, perform "Eject" operation from the PC (or host device) or press the EJECT button on the rear of the drive to eject the cartridge.
Note
EJECT button operation or power off/on operation may generate another alarm code.
ODS-D280U/ODS-D280F
Error remedy method
1.
Eject a cartridge manually.
2.
Visually check the cartridge.
•
If an abnormality (such as bulge) is
found, do not use the cartridge any lon-
ger.
Tip
For how to handle the defective car-
tridge, contact your local Sony Sales
Office/Service Center.
3.
Startup the maintenance menu and perform
LOADER AUTO TEST.
Note
To clear this error, perform LOADER AUTO
TEST
Use another cartridge.
•
When this test ends successfully, the
previous cartridge may be defective.
Do not use the previous cartridge any
longer.
Tip
For how to handle the defective car-
tridge, contact your local Sony Sales
Office/Service Center.
•
When this test ends abnormally, the
select loader assembly may be defec-
tive.
It is recommended to copy data to another cartridge
at your earliest convenience.
For more details, contact your local Sony Sales
Office/Service Center.
Following operation is averted.
•
Multiple file simultaneous reading.
•
Reading the file in writing.
•
Writing the file in reading.
•
Self-file copy in same volume.
Tip
For more information about the deprecated opera-
tions, refer to "Deprecated Operations" of "File
System" for Optical Archive Utility help.
Refer to section
"1-10. How to Eject the Car-
tridge (ODS-D280F)"
"1-11. How to Eject the Car-
tridge Manually"
"4-10. Select Loader Assembly"
1. Press the EJECT button to eject the cartridge.
If the cartridge is not ejected, take the following measures.
• Turn off and on the drive. Press the EJECT button after startup
to eject the cartridge.
• If the cartridge is not ejected even after this operation, eject it
manually.
2. Visually check the cartridge.
• If an abnormality (such as bulge) is found, do not use the
cartridge any longer and go to step 3) in Measures.
Tip
For how to handle the defective cartridge, contact your local
Sony Sales Office/Service Center.
3. Turn off and on the drive.
• When this error occurs again, the select loader assembly may be
defective.
―
―
―
*1
2-49
Advertisement
Table of Contents
