Table of Contents
Advertisement
Procedure
1.
Remove the CA side slider R.
(1) Rotate the CA transmission gear in the direction of the arrow, then move the CA side slider R to the position
where it does not interfere with the carry middle loader.
(2) Remove the two retaining rings, then remove the two bearings (DDL-F-415ZZ).
(3) Remove the CA side slider R.
(4) Remove the two CA lower plate rollers.
Move the CA side slider R
to the position where it does
not interfere with the carry
middle loader.
CA side slider R
Carry middle loader
Carry loader assembly
Apply the grease FLOIL
(FLOIL G-902) (amount of about
1/2 size of a grain of rice) to the
two CA lower plate rollers.
Tip
When attaching the CA side slider R, insert (e) to (h) of the carry loader assembly into (a) to (d) of the CA side
slider R.
ODS-D280U/ODS-D280F
CA transmission gear
Screw hole
CA lower plate rollers
(e)
(a)
(g)
Bearing (DDL-F-415ZZ)
Retaining ring
( f )
CA side slider R
(b)
(h)
(d)
Bearing
(DDL-F-415ZZ)
(c)
Retaining ring
Grease FLOIL
(FLOIL G-902)
4-36
Advertisement
Table of Contents
