Code
Description
13-054
A signal from the disc re-
quired for focus servo of op-
tical block assembly Ch-2A
cannot be detected. (On side
1)
13-0D4
A signal from the disc re-
quired for focus servo of op-
tical block assembly Ch-2B
cannot be detected. (On side
1)
13-154
A signal from the disc re-
quired for focus servo of op-
tical block assembly Ch-3A
cannot be detected. (On side
1)
ODS-D280U/ODS-D280F
Error remedy method
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
4.
Check the carry loader assembly installation
status.
Note
If the carry loader assembly is abnormally
installed, disc chucking is not performed
successfully and focus servo may fail.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
4.
Check the carry loader assembly installation
status.
Note
If the carry loader assembly is abnormally
installed, disc chucking is not performed
successfully and focus servo may fail.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
4.
Check the carry loader assembly installation
status.
Note
If the carry loader assembly is abnormally
installed, disc chucking is not performed
successfully and focus servo may fail.
Refer to section
"3-1. Periodic Inspection"
"4-11. Carry Loader Assembly"
"4-29. Sub Base Assembly"
"5. Adjustment of Optical Drive
System"
"3-1. Periodic Inspection"
"4-11. Carry Loader Assembly"
"4-29. Sub Base Assembly"
"5. Adjustment of Optical Drive
System"
"3-1. Periodic Inspection"
"4-11. Carry Loader Assembly"
"4-29. Sub Base Assembly"
"5. Adjustment of Optical Drive
System"
Continued
2-25