3.
Align the two shafts of the master plate with the two holes on the rear surface of the carry loader assembly, then
slide it in the direction of the arrow (A) as far as it will go.
Note
Before sliding the carry loader assembly, check that the flexible flat cable and fine-wire coaxial cable are not get
caught.
Front side
M2.6 x 4
View on arrow B
Fine-wire coaxial cable
CA lower
BU assembly
Flexible flat cable
Master plate
ODS-D280U/ODS-D280F
Carry loader assembly
M2 x 2.7
A
Carry loader assembly
B
Carry loader assembly
M2 x 2.7
Select loader assembly
Shaft of master plate
A
Carry loader assembly
Shaft of master plate
Front side
M2.6 x 4
4-30