Table of Contents
Advertisement
5.
Check that the cartridge holder (upper) is located in the eject position.
Tip
If the cartridge holder (upper) is not located in the eject position, move it by rotating the worm gear of the top
motor assembly in the clockwise direction using the screwdriver.
Cartridge holder (upper)
Check that the tip of the
SE REC INHI switch arm is
lowered to the position
shown in the illustration.
Note
• Insert the cartridge after attaching the FR front block assembly, MC top reinforcing plate and bottom frame.
• In the Eject state, the tip of the SE REC INHI switch arm is located in the position lower than the under surface
of the cartridge holder. If the cartridge is inserted in the state that the SE rail plate is not adequately moved
to the front side, the tip of the SE REC INHI switch arm may hit against the cartridge and become damaged.
6.
Assemble this unit in the reverse order of preparation.
7.
Reset all corresponding hours meters after replacing the parts. (Refer to
Middle Loader Assembly and Carry Loader
ODS-D280U/ODS-D280F
Screwdriver
Front side
Assembly".)
Worm gear
The bearing position is on the front side.
Front side
RFID antenna
"1-16-2. Select Loader Assembly, CA
<Eject position>
The bearing position is on the rear side.
4-26
Advertisement
Table of Contents
