Table of Contents
Advertisement
3.
Rotate the worm gear of the select loader in the counterclockwise direction to move the SE rail plate to the position
shown in the illustration.
Note
If the worm gear is rotated with additional force from the state that the bearings are stopped at the position where
they come into contact with the rear side, the tooth skipping of the gear may occur.
Screwdriver
4.
Loosen the two screws of step 1, then align the phase of FR lid gear (lower) and SE lid gear arm.
• Make the lids, (upper) and (lower), closed state.
• Adjust the SE lid gear arm so that its 1st teeth is engaged with the FR lid gear (lower) in the position shown
in the illustration.
5.
Tighten the two screws loosened in step 4, then secure the FR front block assembly to the master plate.
ODS-D280U/ODS-D280F
SE rail plate
Worm gear
The bearing position is on the front side
Front side
The bearing position is on the rear side
Upper side
The illustration shows ODS-D280U.
4-10
Advertisement
Table of Contents
