Table of Contents
Advertisement
Code
Description
51-500
An unspecified disc was in-
serted.
53-500
Recording to disc was at-
tempted with no available
spare area.
53-502
An error was detected when
the management information
was recorded in the record-
ing disc.
54-000
Unsupported REC mode was
detected in the recording
disc.
54-001
Unsupported PAC is used in
the recording disc.
54-002
Unsupported spare area is
used in the recording disc.
54-003
Unsupported DFL entry was
detected in the recording
disc.
54-004
A data error was detected
when the cartridge memory
data was read.
54-005
A device error was detected
when data was written to the
cartridge memory.
ODS-D280U/ODS-D280F
Error remedy method
1.
Eject a cartridge.
2.
Check the firmware version.
•
In the case the firmware version is not
the latest, perform the update.
•
When the current firmware version is
the latest, go to step 3) in Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
A drive fault is likely.
Tip
For cartridges that can be read and written by this
unit, refer to the operation manual.
1.
Eject a cartridge.
2.
Insert another cartridge. Record data to the
cartridge.
1.
Eject a cartridge.
2.
Insert another cartridge. Record data to the
cartridge.
Eject a cartridge.
•
Disc containing data written in an unsuppor-
ted format may be within the cartridge.
This is a disabled cartridge.
Eject a cartridge.
•
Disc containing data written in an unsuppor-
ted format may be within the cartridge.
This is a disabled cartridge.
Eject a cartridge.
•
Disc containing data written in an unsuppor-
ted format may be within the cartridge.
This is a disabled cartridge.
Eject a cartridge.
•
Disc containing data written in an unsuppor-
ted format may be within the cartridge.
This is a disabled cartridge.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
Refer to section
"7. Firmware Upgrade"
―
―
―
―
―
―
―
―
Continued
2-59
Advertisement
Table of Contents
