Code
Description
6F-F03
Adjustment failed in starting
optical block assembly
Ch-1A. (On side 0)
6F-F80
Startup adjustment or OPC
cannot be finished in optical
block assembly Ch-1B. (On
side 0)
6F-F83
Adjustment failed in starting
optical block assembly
Ch-1B. (On side 0)
80-E65
An abnormal value was de-
tected in the measurement of
eccentricity in the optical
block assembly Ch-2A. (On
side 1)
ODS-D280U/ODS-D280F
Error remedy method
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
1.
Eject a cartridge.
2.
Insert again the ejected cartridge.
•
When no error occurs, use the unit as
it is.
•
When an error occurs, go to step 3) in
Measures.
3.
Insert another cartridge.
•
In the case no error occurs:
The ejected cartridge is likely to be
faulty.
•
In the case the error occurs:
Drive trouble is likely.
4.
Check the carry loader assembly installation
status.
Note
If the carry loader assembly is abnormally
installed, disc cannot be chucked normally
and the eccentricity may increase.
Refer to section
―
―
―
"4-11. Carry Loader Assembly"
Continued
2-64