Table of Contents
Advertisement
Procedure
1.
Remove the JS BF heat sink.
(1) Remove the tape AS.
(2) Remove the three screws, then remove the JS bottom duct.
(3) Remove the five screws, then remove the JS BF heat sink.
JS bottom duct
Front side
Radiation sheets
(ODS-D280F)
The illustration shows ODS-D280U.
Note
When attaching the tape AS, be careful that the harnesses do not protrude from the upper end of the JS fan fixing
holder.
Tip
If the radiation sheet is adhered to the JS BF heat sink, attach it to the BI-353/BF-92 board.
ODS-D280U/ODS-D280F
PSW2 x 5
BI-353 board: ODS-D280U
BF-92 board: ODS-D280F
PSW2 x 5
JS BF heat sink
Radiation
sheet
n
Secure the three harnesses with the
tape AS as shown in the illustration so
that they do not protrude from the
JS bottom duct.
Tape AS
JS bottom duct
Three harnesses
Be careful that the three harnesses
do not ride on the connector.
Connector
4-14
Advertisement
Table of Contents
