Table of Contents
Advertisement
4-18.
SM-50 Board
Preparation
1.
Remove the top cover assembly. (Refer to
2.
Remove the bottom plate assembly. (Refer to
3.
Remove the MC top reinforcing plate. (Refer to
4.
Remove the RE rear assembly. (Refer to
5.
Remove the power block. (Refer to
6.
Remove the carry loader assembly. (Refer to
7.
Remove the CA upper assembly. (Refer to
8.
Remove the CA upper BU assembly. (Refer to
9.
Remove the CA middle loader assembly. (Refer to
Procedure
1.
Slide the portion (g) of the CA middle base assembly in the direction of the arrow so that the return arm becomes
popped out state.
2.
Remove the four screws, then remove the CA middle arm plate assembly.
3.
Remove the screw, then remove the SM-50 board.
Return arm
CA middle arm plate assembly
Portion (g)
CA middle base assembly
Tip
When attaching the CA middle arm plate assembly, tighten the screws in the order from (a) to (d).
ODS-D280U/ODS-D280F
"4-2. Top Cover
"4-3. Bottom Plate
"4-4. MC Top Reinforcing
"4-7. RE Rear
Assembly".)
"4-8. Power Supply
"4-11. Carry Loader
"4-14-1. CA Upper
"4-14-2. CA Upper BU
"4-15. CA Middle Loader
(c)
CA middle slider L assembly
Assembly".)
Assembly".)
Plate".)
Block".)
Assembly".)
Assembly".)
Assembly".)
Assembly".)
(d)
(a)
M2 x 2.7
SM-50 board
M2 x 2.7
(b)
CA middle slider R assembly
Portion (g)
4-46
Advertisement
Table of Contents
