Table of Contents
Advertisement
14. Attach the top cover assembly. (Refer to
Note
• Be sure to attach the top cover assembly.
• Do not turn on the power with the top cover assembly removed.
• If the power is turned on with the top cover assembly removed, it may cause injury, electrical shock or disorder
due to the laser light.
• Route the two flexible flat cables that are not connected in step 13 to the outside of the top cover assembly.
Care should be taken because if the cable enters inside of the assembly, it may cause a short circuit of power
supply.
Top cover assembly
15. Turn on the power of this unit.
16. Display the maintenance menu referring to
17. Move the cursor to "CHECK" using [UP]/[DOWN] buttons.
18. Press the [RIGHT] button.
ODS-D280U/ODS-D280F
"4-2. Top Cover
Assembly")
"6-2. Starting the Maintenance
Flexible flat cables
PP-61 board
PP-61 board
Menu".
3-21
Advertisement
Table of Contents
