Table of Contents
Advertisement
4-21.
PP-62 Board
Tip
The following part cannot be reused. Prepare the new part.
• JS dust-proof sheet PWR connector
Preparation
1.
Remove the top cover assembly. (Refer to
2.
Remove the bottom plate assembly. (Refer to
3.
Remove the MC top reinforcing plate. (Refer to
4.
Remove the RE rear assembly. (Refer to
5.
Remove the power block. (Refer to
Procedure
1.
Remove the screw [A], then remove the PP-62 board.
2.
Remove the screw [B], then remove the JS power GND metal plate.
3.
Disconnect the harness from the connector (CN61) on the PP-62 board.
4.
Remove the JS dust-proof sheet power connector.
JS dust-proof sheet PWR connector
Screw [B]
(M2 x 2.7)
CN61
PP-62 board
JS power GND plate
5.
Install the removed parts by reversing the steps of removal.
ODS-D280U/ODS-D280F
"4-2. Top Cover
"4-3. Bottom Plate
"4-4. MC Top Reinforcing
"4-7. RE Rear
"4-8. Power Supply
Fan fixing holder
Screw [A]
(M2 x 2.7)
Assembly".)
Assembly".)
Plate".)
Assembly".)
Block".)
Fan block
PP-61 board
Connection of harness
Upper surfaces of fan
fixing holder
CN62
PP-61 board
n
Be sure that the height of the connected
harness is lower than the upper surfaces
of the fan fixing holder.
Harness
4-53
Advertisement
Table of Contents
