Table of Contents
Advertisement
6.
Rewrite the underlined part to the drive letter checked in step 4.
[FORM]
LEFT=32
TOP=189
[PDW]
DRIVE=D
Rewriting to the drive letter of the unit.
VERSION=1.00
(default setting: F)
7.
Save the PDWTerminal.ini file and close it.
8.
Execute the PDWTerminal.exe file in the PDWTerminal folder.
Details of the PDWTerminal window
Error message area
(1) SET button
(2) EXIT button
(3) UP/DOWN buttons
(4) LEFT button
(5) RIGHT button
Status area
No.
Button Name
1
SET button
2
EXIT button
3
UP/DOWN button
4
LEFT button
5
RIGHT button
Tip
When there are instructions to press "MENU KEY" in the menu screen, click the [LEFT] button (No. 4).
If the maintenance menu does not work normally
If the maintenance menu is not displayed on the menu window, the following possible causes are considered. Clear the
possible causes and then click the [EXIT] button to exit the program. Then re-execute the PDWTerminal.exe file.
Symptom:
"USB DEVICE NOT READY" appears in the status area.
Possible cause:
• This unit is not powered on.
• No cable is connected.
• An incorrect drive letter is set.
• This unit is not recognized by the PC due to a cause other than above.
Symptom:
"ABORTING" appears momentarily on the menu window and "COMMAND SEQUENCE ERROR" appears in the
error message area.
ODS-D280U/ODS-D280F
SET(0x01)
DRIVE MAINTENANCE
EXIT(0x02)
>
CHECK
ADJUST
UP(0x05)
ERROR LOGGER
OTHERS
DOWN(0x06)
LEFT(0x07)
RIGHT(0x08)
USB DEVICE READY
Description
Executes the selected menu and items in the menu.
Exits the maintenance mode.
Moves the cursor on the menu.
Moves to one-level higher menu layer and exits a menu.
Moves to one-level lower menu layer.
Menu window
6-3
Advertisement
Table of Contents
