Table of Contents
Advertisement
7.
Drop the two drops of pure water to each of the eight lens cleaners attached to the "WET" side of the lens cleaning
base (280) assembly and lens cleaning base (280) using the dropper.
Note
If the pure water is dropped excessively, it may be dropped onto the optical drive assembly, which may cause a
failure. Be careful not to drop the pure water excessively.
Lens cleaners
8.
Place the lens cleaning bases so that each surface (to which the lens cleaners are attached) faces each other. Insert
the positioning pins of the lens cleaning base (280) assembly into the positioning holes of the lens cleaning base
(280). Combine the lens cleaning bases.
Lens cleaning base (280)
Positioning hole
Positioning pin
ODS-D280U/ODS-D280F
Lens cleaners
Lens cleaning base (280) assembly
and lens cleaning base (280)
Positioning hole
Positioning pin
Lens cleaner attached surface
Lens cleaning base (280) assembly
Dropper
Pure water
Lens cleaners
Combined lens cleaning base
3-16
Advertisement
Table of Contents
