Table of Contents
Advertisement
2.
Install the removed parts by reversing the steps of removal.
Note
• If the return arm is popped out, it may be deformed. Therefore, slide the portions (g) in the direction of the
arrow to put the return arm inside of the CA middle loader assembly, then continue the procedure.
• Before attaching the CA upper BU assembly, check for the falling of the CA gear (floor through).
Tip
• Confirm the front/rear direction of the CA upper BU assembly and place it under the portion (A) of the CA
middle loader assembly. Then, insert the bearing on the L side of the CA upper BU assembly into the groove
on the L side of the CA lower plate.
• Insert the bearing on the R side of the CA upper BU assembly into the groove on the R side of the CA lower
plate.
View on arrow B
L side of CA lower plate
CA upper BU assembly
L side of bearing
Portion (A)
Groove on L side of CA lower plate
CA middle loader assembly
Front side
Note
Be careful when handling the CA upper BU assembly because it is attached in unstable state.
ODS-D280U/ODS-D280F
L side of bearing
DR-683 board
Portion (A) B
Portion (g)
Return arm
CA upper BU assembly
R side of
bearing
Groove on R side of
CA lower plate
Portion (g)
CA gear (floor through)
4-41
Advertisement
Table of Contents
