Table of Contents
Advertisement
2.
Move the SE rail plate to the position shown in the illustration.
(1) Rotate the worm motor to set the bearing to a specified point of scale of the SE elevating rail.
Tip
The point of scale to which the bearing is set varies depending on the remaining number of discs.
Example 1)
When the 1st disc is in Generation 1
Bearing
Example 2)
When the 5th disc is in Generation 1
3.
Make the disc capable of carrying state.
(1) Rotate the CA transmission gear of the CA motor (V) assembly in the counterclockwise direction to move
the CA side slider R to the position (home position) shown in the illustration. (The upper and lower base units
are separated, and the disc becomes unchuck state.)
ODS-D280U/ODS-D280F
Bearing
SE rail plate
SE elevate rail
Bearing
Generation 2
(scale for 11 discs)
Bearing
Worm gear
Front side
Generation 1
(scale for 12 discs)
Select loader
assembly
Screwdriver
1-20
Advertisement
Table of Contents
