3.
Disconnect the flexible flat cable from the connector (CN761) on the SM-48 board. (ODS-D280U)
Note
• When rotating the worm gear using the screwdriver, be careful not to cause the tooth skipping of the gear due
to excessive rotation.
• The SE rail plate is pulled by the spring. If a force in the direction opposite to the worm wheel is applied to
the tip of the worm gear, the tooth skipping of the gear may easily occur. Therefore, carefully rotate the worm
gear.
Approx. 10 mm
Worm gear
Screwdriver
Rear side of select loader assembly
CN761
Flexible flat cable
ODS-D280U/ODS-D280F
SE rail plate
SM-48 board
CN761
SM-48 board
Upper side
The illustration shows ODS-D280U.
4-8