Se Anti-Static Brush Assembly - Sony ODS-D280U Service Manual

4-28.

SE Anti-Static Brush Assembly

Preparation
1. Remove the top cover assembly. (Refer to
2. Remove the bottom plate assembly. (Refer to
3. Remove the MC top reinforcing plate. (Refer to
4. Remove the FR front panel assembly (ODS-D280U). (Refer to
5. Remove the FR front block assembly. (Refer to
6. Remove the select loader assembly. (Refer to
Procedure
1. Remove the screw, then remove the SE anti-static brush assembly.
Select loader assembly
Front side
2. Install the removed parts by reversing the steps of removal.
Note
• After replacement, reset Disc Guide Counter. (Refer to
• Be careful not to contaminate the brush portion of the SE anti-static brush assembly. Be sure to hold the plate
portion during the work and do not touch the brush portion.
ODS-D280U/ODS-D280F
"4-2. Top Cover Assembly".)
"4-3. Bottom Plate Assembly".)
"4-4. MC Top Reinforcing
"4-5. FR Front Panel Assembly
"4-6. FR Front Block Assembly".)
"4-10. Select Loader Assembly".)
SE anti-static brush assembly
"6-7-8. RESET
Plate".)
(ODS-D280U)".)
n
Do not touch this screw.
If it is accidentally loosened,
replace it with a new select
loader assembly.
M2 x 2.7
HOURS".)
4-64