For Linux
Check
Open the terminal, execute the following command, and then check that "ODS-D280F" for connected devices is shown
in the "Model" field.
# cat /proc/scsi/scsi
Attached devices:
Host: scsi9 Channel: 00 Id: 00 Lun: 00
Vendor: SONY
Type:
Optical Device
Measures
If indication cannot be checked in Check, perform the following procedure to check whether the indication in the "Model"
field becomes normal.
1.
Restarting the drive:
(1) Check the serial number of the drive shown by the utility software (Optical Disc Archive Utility).
(2) On the Web UI (Optical Disc Archive Library Maintenance Web UI) drive setting tab of ODS-L30M, restart
the drive whose serial number is not shown.
(3) After about one minute has passed after restart, perform Check again and check the indication of the "Model"
item.
2.
After about one minute has passed after the connected equipment is restarted, perform Check again and check the
indication in the "Model" field.
ODS-D280U/ODS-D280F
Model: ODS-D280F
Check:
ODS-D280F
Rev: 1300
ANSI
SCSI revision: 00
1-9