Table of Contents
Advertisement
2.
Remove the two screws, then remove the CA motor (V) assembly.
Dowel hole
SM-45 board
Tip
• When attaching the CA motor (V) assembly, apply the grease FLOIL (FLOIL G-902) to the helical gear.
• When attaching the CA motor (V) assembly, in order to properly apply pressure to the motor sheet, align the
dowel on the round hole side (a) first, and then insert the dowel on the elongate hole side while rotating the
motor assembly in the clockwise direction around the round hole. Then, tighten the screws.
3.
Install the removed parts by reversing the steps of removal.
Tip
When connecting the harness, connect it so that the heat-shrinkable tube fits between the clampers.
SM-45 board
CN2
Clamper
Note
After replacement, reset the Carry Motor (V) Counter. (Refer to
ODS-D280U/ODS-D280F
M2 x 2.7
(a)
CA motor (V) assembly
CA motor (V) assembly
Clamper
Heat-shrinkable tube
Apply the grease FLOIL (FLOIL G-902)
to the three portions of the helical gear
(1/2 size of a grain of rice for each
portion). Rotate the helical gear in the
direction of the arrow for allowing the
grease to spread evenly.
Upper side
Rear side
"6-7-8. RESET
HOURS".)
Helical gear
4-34
Advertisement
Table of Contents
