2.
While aligning the two gate plate holes of the select loader assembly with the two pins of the carry loader assembly,
hook the two notches on the hooks. Then, slide and push it to the rear side securely.
Tip
Check that the mounting screw holes of the select loader do not ride on the ribs of the master plate boss. Then,
tighten the two screws.
B2.6 x 4
n
Do not touch this screw. If it is
accidentally rotated, replace it
with a new select loader
assembly.
Rib of master plate
stepped boss
Hole
Select loader assembly
ODS-D280U/ODS-D280F
B2.6 x 4
Pin
Rib of master plate
stepped boss
Hole
Gate plate
Select loader assembly
Hook the notches on the
hooks.
Pin
Upper side
Carry loader assembly
Notch
Hook
4-23