Basic Setting; Chapter 8 Basic Setting; Overview; What You Can Do - ZyXEL Communications XS1930-12HP User Manual

8.1 Overview

This chapter describes how to configure the System Info, General Setup, Switch Setup, IP Setup, Port
Setup, PoE Setup, Interface Setup, IPv6, DNS and Cloud Management screens.

8.1.1 What You Can Do

• Use the System Info screen
monitor the Switch temperature, fan speeds and voltage.
• Use the General Setup screen
system name and time.
• Use the Switch Setup screen
and assign priorities to queues.
• Use the IP Setup screen
device, and the management VLAN ID.
• Use the Port Setup screen
• Use the PoE Setup screens
receiving from the Switch and set the priority levels for the Switch in distributing power to PDs. This
screen is available for PoE model(s) only.
• Use the Interface Setup screens
interface ID settings.
• Use the IPv6 screens
• Use the DNS screen
• Use the Cloud Management screen
Center Discovery and Nebula Switch Registration screens.

8.2 System Information

In the navigation panel, click Basic Setting > System Info to display the screen as shown. Use this screen
to view general system information. You can check the firmware version number and monitor the Switch
temperature, fan speeds and voltage in this screen.
(Section 8.2 on page
(Section 8.3 on page
(Section 8.5 on page
(Section 8.6 on page
(Section 8.7 on page
(Section 8.8 on page
(Section 8.9 on page
(Section 8.10 on page 98) to view IPv6 status and IPv6 configuration.
(Section 8.11 on page 111) to configure the default domain name server.
(Section 8.12 on page
XS1930 Series User's Guide
79
C
H A P T E R

Basic Setting

79) to check the firmware version number and
81) to configure general settings such as the
84) to choose your VLAN type, set the GARP timers
85) to configure the Switch IP address, default gateway
89) to configure Switch port settings.
90) to view the current amount of power that PDs are
97) to configure Switch interface type and
112) to display links to Nebula Control
8