Erase Running-Configuration; Save Configuration; Reboot System - ZyXEL Communications XS1930-12F User Manual

37.2.1 Erase Running-Configuration

Follow the steps below to remove the running configuration on the Switch. Unlike when you reset the
Switch to the factory defaults, the user name, password, system logs, memory logs, baud rate and SSH
service are not removed.
In the Maintenance screen, click the Click Here button next to Erase Running-Configuration to clear all
1
Switch configuration information you configured and return to the Zyxel default configuration settings.
Click OK to reset all Switch configurations.
2
Figure 212 Erase Running-Configuration: Confirmation
In the Web Configurator, click the Save button in the top of the screen to make the changes take
3
effect. If you want to access the Switch Web Configurator again, you may need to change the IP
address of your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1
or DHCP-assigned IP).

37.2.2 Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.
These configurations are set up according to your network environment.
Click Config 2 to save the current configuration settings permanently to Configuration 2 on the Switch.
These configurations are set up according to your network environment.
Click Custom Default to save the current configuration settings permanently to a customized default file
on the Switch. If configuration changes cause the Switch to behave abnormally, click Custom Default
(next to Reboot System) to have the Switch automatically reboot and restore the saved Custom Default
configuration file.
Alternatively, click Save on the top right in any screen to save the configuration changes to the current
configuration.

37.2.3 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or the Factory
Default configuration when you reboot. Follow the steps below to reboot the Switch.
In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
1
configuration file. The confirmation screen displays.
Click OK again and then wait for the Switch to restart. This takes up to 2 minutes. This does not affect the
2
Switch's configuration.
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Chapter 37 Maintenance
XS1930 Series User's Guide
296