Ipv6 Interface Setup - ZyXEL Communications XMG1930-30 User Manual

Figure 108 SYSTEM > IPv6 > IPv6 Global Setup
The following table describes the labels in this screen.
Table 63 SYSTEM > IPv6 > IPv6 Global Setup
LABEL
IPv6 Hop Limit
ICMPv6 Rate
Limit Bucket
Size
ICMPv6 Rate
Limit Error
Interval
Apply
Cancel
Clear

24.4 IPv6 Interface Setup

Use this screen to view and configure an IPv6 interface you create in the SYSTEM > Interface Setup
screen. Click SYSTEM > IPv6 > IPv6 Interface Setup to display the screen as shown next.
Figure 109 SYSTEM > IPv6 > IPv6 Interface Setup
The following table describes the labels in this screen.
Table 64 SYSTEM > IPv6 > IPv6 Interface Setup
LABEL
Index
Interface
Active
Chapter 24 IPv6
DESCRIPTION
Specify the maximum number of hops (from 1 to 255) in router advertisements. This is the
maximum number of hops on which an IPv6 packet is allowed to transmit before it is discarded by
an IPv6 router, which is similar to the TTL field in IPv4.
Specify the maximum number of ICMPv6 error messages (from 1 to 200) which are allowed to
transmit in a given time interval. If the bucket is full, subsequent error messages are suppressed.
Specify the time period (from 0 to 2147483647 milliseconds) during which ICMPv6 error messages
of up to the bucket size can be transmitted. 0 means no limit.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
Click Clear to reset the fields to the factory defaults.
DESCRIPTION
This is the interface index number.
This is the name of the IPv6 interface you created.
This field displays whether the IPv6 interface is activated or not.
XMG1930 Series User's Guide
176