Table of Contents
Advertisement
PLC commissioning
5.4 Creating a PLC program
Note
Copy additional objects separately (e.g. variables or PLC data types)
When you copy the program blocks, objects that belong together, such as variables, PLC
data types or technology objects, are not automatically included in the copy. This applies
both to copying from reference projects and to copying to another PLC.
Error messages are issued during the compilation, e.g. if the variables used in the copied
program block are not defined in the variable table.
Therefore, additionally copy the objects used by the copied blocks.
Note
Conflicts due to names, addresses or numbers that are used multiple times
When you paste objects from a reference project whose names have already been used in
the project, these are automatically renamed under certain circumstances:
● If you copy objects with the same name into the same folder or the same group,
● If you copy objects with previously assigned names to a different folder (or group), the
A check for duplicate block numbers or addresses is, however, only performed during
compilation.
84
the "Conflicts when copying" dialog (Page 85) is displayed.
newly inserted objects are renamed without asking.
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Advertisement
Table of Contents
