Starting Up The Replacement Ssd - Siemens SINUMERIK MC Commissioning Manual

Procedure
Proceed as follows to connect a shared directory as a network drive:
1. Start the Windows Explorer and click the "Map network drive" button.
2. Make the following settings in the "Map network drive" dialog box:
3. Confirm your settings with "Finish".
10.5.13

Starting up the replacement SSD

Further information
Further information on the replacement or installation of an SSD can be found in the hardware
documentation for your PC system in the SIMATIC IPC Operating Instructions:
Note
Troubleshooting if reading in of the disk image fails
If data transfer is interrupted during the reading process, there will be no executable operating
system available on the Siemens PC system.
In this case, use a bootable USB flash drive with Service Center to read the disk image in again.
Further information to restore a disk image is provided under Restore a disk image of the SSD
(Page 253).
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Setting Purpose
Drive Select drive letters under which the network directories are to be accessible on
the PC system.
The drive letters Z, Y and X are assigned to USB interfaces at the operator
panels. Do not use these drive letters for other purposes in order to avoid
problems when using these USB interfaces.
Folder Specify the device in the network and share name of the resource.
Syntax: \\Name of the server\share name of the network
directory
Example: \\Backup_Server\PCU_Backup
Reconnect at logon Activate this checkbox to automatically connect the network drive while run‐
ning up.
Connect using dif‐ Activate this checkbox if you have not shared the directory in the network with
ferent credentials the user for whom you would like to set up the network drive.
In the next dialog box "Enter Network Password," enter the log-on information
of a user with whom the network directory is shared.
Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
271