Table of Contents
Advertisement
Procedure
Proceed as follows to configure the SITOP software for use with PCU Base for IPC:
1. Call the settings of the SITOP software, for example, by right-clicking the SITOP UPS icon
in the Windows information area and then selecting "Configuration".
The "SITOP DC UPS Configuration" dialog box opens.
2. In the "General" tab, select "UPS" in the drop-down list at "Serial interface".
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Installing and setting up PCU Base for IPC
10.3 Configuration of the system
193
Advertisement
Table of Contents
