Table of Contents
Advertisement
To view the directory, proceed in one of the following ways:
● To switch quickly to a hidden directory, type the address in the Windows Explorer.
● To show all hidden directories by default, change the setting in the Control Panel under
"Appearance and Personalization > File Explorer Options > View > Advanced Settings".
● To show only one directory by default, first make the setting to show all hidden directories,
then activate the attribute "Hidden" in the properties of the directory and finally again make
the setting to not show all hidden directories.
Your settings
Several directories are available into which you can copy and adapt configuration files in order
to make your own settings. In decreasing order of priority, these are:
● C:\ProgramData\Siemens\MotionControl\user\
● C:\ProgramData\Siemens\MotionControl\oem\
● C:\ProgramData\Siemens\MotionControl\addon\
The settings in a configuration file in a directory with higher priority always replace those from
one of lower priority. Template directory siemens has the lowest priority.
To define your own settings, therefore, copy a setting from the relevant template file into a
directory with higher priority, e.g. below directory user.
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Installing and setting up PCU Base for IPC
10.1 Delivery state
179
Advertisement
Table of Contents
