If the HMI software of your OEM installation is not shut down within 180 seconds, you can
parameterize this wait time manually.
Note
Information about the test environment for machine OEMs
The function "SITOP UPS" has been tested in the standard configuration with
PCU Base for IPC. When installing add-on or OEM software components, you must check the
shutdown procedure of the entire system and adapt the factory setting.
Precondition
● The SITOP UPS module is configured for use with PCU Base for IPC.
For further information see under Configuring SITOP software V3.x (USB) (Page 191).
● The Service Desktop is active.
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Installing and setting up PCU Base for IPC
10.3 Configuration of the system
195