Table of Contents
Advertisement
Result
The routing has been configured and the PG/PC and Siemens PC system are connected via
the NC.
Now, perform the desired steps, for example, a Restore a disk image of the SSD (Page 253).
10.5.12.4
Configure the network settings of the PG/PC
Once you have connected a PG/PC in the network, make the network settings on the PG/PC.
The basic procedure for setup under Windows 10 or Windows 7 is described below. Further
information from Microsoft is in the Internet: Microsoft Windows support
support.microsoft.com/en-us/hub/4338813/windows-help?os=windows-10)
Precondition
● The PG/PC is linked with the Siemens PC system in one of the following ways:
– The PG/PC is connected to the PC system using an Ethernet cable (either directly or
– The PG/PC is networked with the PC system via an interface of the NC and the routing
● A current Microsoft Windows operating system is installed on the PG/PC
● The PG/PC is switched on
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
using a switch)
Further information: Connection options in the system network (Page 262)
is configured.
Further information: Configuring routing in the network (Page 263)
Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
(https://
265
Advertisement
Table of Contents
