Table of Contents
Advertisement
Install WinCC RT Advanced on the PC system if you wish to use the PC system for using the
customized user interfaces.
You can configure and customize the operating area.
Further information on this topic is provided in the TIA Portal help in Chapter "SINUMERIK user
interfaces".
Precondition
● A project is open in the TIA Portal.
● A SINUMERIK MCU has been created.
● The device view is active.
Procedure
1. Double-click "Device configuration" under "PC system" in the project tree.
The device configuration for the PC system is displayed.
2. In the Hardware catalog, select the runtime software under "SIMATIC HMI application >
WinCC RT Advanced" and drag it to a free slot of the device in the Network view.
Result
In the project tree, the configured Runtime "HMI_RT_1 [WinCC RT Advanced]" is added to the
created PC system.
This view provides the following configuration editors, among others:
● "Connections"
● "HMI variables"
● "HMI messages"
● "Screens"
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
PLC commissioning
5.3 Configuring the PLC
53
Advertisement
Table of Contents
