Table of Contents
Advertisement
Table 10-17 IP settings in the "Network Settings" dialog box
Section
Adapter configuration
Host configuration
Routing settings
You can make the following routing settings in the "Network Settings" dialog box:
MCU commissioning: NC, PLC, Drive
Commissioning Manual, 02/2020, A5E47437618B AB
Setting
Adapter
DHCP Enabled
Address
Subnet
Default Gateway
Name Server
Suffix Search List
Installing and setting up PCU Base for IPC
10.5 Backing up and restoring data
Purpose
Select the Ethernet interface that you want to
configure.
All settings in Section "Adapter configuration"
refer to the selected Ethernet interface.
Select whether the addresses are to be fetch‐
ed dynamically from the DHCP server.
If the checkbox is deactivated, you must
make the settings manually.
Set the IP address of the NCU.
You can specify an IP address from the fol‐
lowing range:
192.168.214.250 - 254
Specify a subnet mask, e.g. 255.255.255.0
Set the IP address of the standard gateway.
A standard gateway creates a standard route
in the IP routing table for all destinations that
are not in the subnet.
Set the IP address of the name server.
A name server answers questions asked
about a domain name zone using a DNS da‐
tabase.
Parameterize a search list for DNS suffix, e.g.
"network.com".
The factory setting of the Ethernet interface
"Local Area Connection" is ".local".
249
Advertisement
Table of Contents
